Fiesta 1.25 Petrol 2005 Engine not cranking

[avc]

Peter lets roll back a bit.

firstly what tool are you using? Can you list what modules have what fault codes?

if you have 60 ohms across 6 and 14 then how are you measuring the the pcm pins? is that with the harness connected or disconnected? if its disconnected then the ohms reading would be right?

what voltage do you have at pin 6 and 14?

Regards darren

[nortfitter]

Hello again

Just to update this fault, It is now fixed.

When I finally got the correct instrument panel wiring diagram and checked all feeds and earths the 12volt feed from fuse 20 to pin 17 on pod was faulty, 12v ok at fusebox so I opened the loom up and traced fault to a corroded multiblock connector behind n/s/f kick panel.

Bypassed all the corroded terminals and away she went.

It looks as if this could be a common problem on these as water follows down the harness to the multiblock connector.

Thanks

Peter